![]() This will need to be done with a scan-tool once the appropriate repairs have been completed.Ħ. Of course, Chrysler/Jeep does not provide a means for resetting MIL’s, this process is for reading codes only. If no DTC’s have been logged, the dash marks will read “-done-“ indicating that the scan is complete.ĥ. You can cross reference your findings with the DTC list below.Ĥ. If DTC’s have been logged, write them down. ![]() If you have conducted the procedure correctly, all fault indicators will remain illuminated and six dash marks “-“ will display in place of the odometer mileage.ģ. If you move too slowly the odometer will indicate mileage, and you will need to start again.Ģ. *Tip: You must cycle the key on and off rapidly while pressing the key into the ignition switch. Cycle the ignition switch on and off three times, halting at the “ON” position. ![]() This procedure is fairly straight forward and, to my knowledge, will work with all Chrysler products dating back as far as the 1980's -the oldest models require counting the duration and number of flashes produced by the CEL, then cross referencing them to a DTC list.ġ. Although this procedure is not as useful or effective as a scan tool, it may help reduce some stress when you find your MIL illuminated while off the grid. The purpose to this post is to provide Jeep owners with a means to run DTC without the need for a scan tool.
0 Comments
Leave a Reply. |